中文简体          ENGLISH

>
VICTREX PEEK

Add: No.8, Jinqiu Road, Lijia Industrial Park, Wujin District, Changzhou City,China    Tel:+86 519 83665281      Fax:+86 519 83665289    Email:info@ybpeek.com                     

Copyright©2016 Changzhou Yongbang Plastics Co., Ltd. All Rights Reserved  苏ICP备13050267号-1   

PRODUCTS

Products Detail

VICTREX PEEK

Polyetheretherketone can be used at very high temperatures (about +260 °C) and it shows an extraordinary mechanical strength, toughness, hardness, flexural strength, torsional strength. PEEK exhibits excellent chemical resistance, very good dielectric properties up to +260 °C and a very good resistance to all kinds of radiation (even ultraviolet rays only lead to a slight yellow discolouration of its self-extinguishing properties according to UL 94.

Properties:

very high mechanical strength

very high rigidity (also at low temperature)

very high thermal stability

very high creep resistance

very high dimensional stability

very high radiation resistance

very high hydrolysis resistance

relatively low notch impact-strength

low resistance to acetone

Application:

earing shells, piston rings, valve seats, gears, seals, aviation, cog-wheels, pump vanes, fittings, plug connectors for thechromatography, wafer carriers, semiconductor industry.

Product Overview

Excellent chemical resistance

Very low moisture absorption

Inherently good wear and abrasion resistance

Unaffected by continuous exposure to hot water or steam

VICTREX PEEK grades offer chemical and hydrolysis resistance similar to PPS, but can operate at higher temperatures. PEEK 450G offers steam and wear resistance, while carbon-reinforced PEEK provides excellent wear capabilities. Our latest grade, PEEK HPV, offers outstanding bearing performance. PEEK can be used continuously to 480°F (250°C) and in hot water or steam without permanent loss in physical properties. For hostile environments, PEEK is a high strength alternative to fluoropolymers. PEEK carries a V-O flammability rating.

Victrex® PEEK 450G/ 151G

This general purpose grade is unreinforced and offers the highest elongation and toughness of all PEEK grades. The newly available black PEEK 1000 is ideal for instrument components where aesthetics are important, as well as for seal components where ductility and inertness are important.

Victrex® PEEK® 450GL30 And 150GL30(30% Glass-Reinforced)

The addition of glass fibers significantly reduces the expansion rate and increases the flexural modulus of PEEK. This grade is ideal for structural applications that require improved strength, stiffness or stability, especially at temperatures above 300°F (150°C).

Victrex® PEEK 450CA30 And 150CA30 (30% Carbon Fiber-Reinforced)

The addition of carbon fibers enhances the compressive strength and stiffness of PEEK, and dramatically lowers its expansion rate. It offers designers optimum wear resistance and load carrying capability in a PEEK-based product. This grade provides more thermal conductivity than unreinforced PEEK -- increasing heat dissipation from bearing surfaces improving bearing life and capability.

Victrex® PEEK 450FC30 And 150FC30(Bearing Grade)

Carbon fiber reinforced with graphite and PTFE lubricants, our newest grade of PEEK offers the lowest coefficient of friction and the best machinability for all PEEK grades. An excellent combination of low friction, low wear, high LPV, low mating part wear and easy machining, make it ideal for aggressive service bearings.

PEEK Plates

peek valve plate

peek screw

PEEK Bearing

vacuum pump vanes

peek gear

peek valve seat

Wafer Cassette

PEEK Bearing Retainer

Page up
1